 |
 |
 |
|
The Clamp on Adjustable Gas Block from ODIN Works is truly adjustable and packed with features. Machined from steel and black nitrided for durability, our clamp on adjustable gas block is equipped with a front facing stainless steel adjustment screw and spring to handle high temperatures. 20 clicks of ball detent adjustment, no set screws needed, simply adjust the stainless screw where you want it and you’re done. An adjustable gas block can reduce your recoil, reduce wear, and allow for a variety of different custom options on your rifle. Why would you choose a clamp on adjustable gas block instead of a regular adjustable gas block? Two main reasons are because it won't mark up your barrel like regular set screws might, and you have greater control over the pressure that is applied on the barrel from tightening the gas block, ensuring that it's is evenly distributed.
A traditional, fixed gas block allows a fixed amount of gas to flow through the system. It's a one size fits all solution for rifles with gas systems. A fixed gas block will almost always be over gassed so that it can cycle the rifle with a variety of ammunition and other variables that effect the rifle cycling. However, there are many downsides to having an over gassed rifle. These downsides include excessive recoil, more wear and tear, running hotter and dirtier, and being less reliable, just to name a few.
A solution to all that? Enter the adjustable gas block. With an ODIN Works Adjustable Gas Block, you'll have 20 pre-set micro adjustments to reduce or increase the gas flow on your rifle. This allows you to run just the right amount of gas to cycle your rifle perfectly, while having minimal recoil (increasing accuracy), run more efficiently and cooler, less wear on your rifle, and allowing customizations such as running different bolt carrier groups, different buffer weights, adding a suppressor, or running different ammunition.
Simply put, an adjustable gas block is one of, if not the most effective way to improve how your rifle runs for the least amount of money.
The ODIN Works clamp on adjustable gas block will fit any barrel with .750" diameter and works with any caliber.
|
|
|
 |
|
 |
|
|
|
 |
|
 |
|
Features
- Not for use with pistol length gas systems.
- Fits inside all ODIN Works Forends.
- Fits .750" diameter barrels.
- Weight: 2.25 oz (includes detent ball, screws and pin).
- Made from Carbon Steel.
- Nitride finish. Heat treated Inconel adjustment screw and spring.
- 20 adjustments.
- Includes detent ball, cross pin, set screws, and hex wrenches.
To Disassemble for Periodic Cleaning:
1. Loosen set screw #1
2. Loosen and remove screw #2.
3.Carefully remove spring and detent ball.
4. Remove gas adjustment screw #3.
5. Soak in cleaning solvent.
|
|
|
|
|
|
|
22arc build 
