 |
The OSM (ODIN Works Suppressor Mount) 5 serves as a proprietary mount for the ODIN Works BRIMSTONE suppressor. The OSM 5 also serves as a stand-alone compensator, greatly reducing both recoil and muzzle rise getting you back on target for faster follow up shots. Machined from stainless-steel, then heat treated, the OSM provides maximum strength and reliability under even the most unforgiving circumstances. The black nitride treated collar provides a highly corrosion resistant, hardened finish. With no shims or washers needed, the OSM is easily installed using a ¾” wrench tightened to 35 foot-pounds.
- WARNING: Ensure Firearm is unloaded and safe before installing or removing ODIN Works parts. Failure to do so could result in serious personal injury or damage to the firearm.
OSM INSTALLATION
- Remove magazine from firearm and check to make sure the chamber is clear.
- Remove any existing thread protector from barrel.
- Hand screw OSM (ODIN Suppressor Mount) compensator onto the barrel until snug.
- Tighten down to 35 foot-pounds with a torque wrench
|
|
|
